Craftsman 917.25025 Manual De Usuario página 8

Your new tractor has been assembled at the factory with exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your tractor
all parts and hardware you assemble must be tightened securely. Use the correct tools
as necessary to insure proper tightness. ADJUST SEAT
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed,
(2) 7/I6" wrenches Utility knife
(1) 1/2" wrench Tire pressure gauge
(1) 3/4" wrench Pliers
(1) 3/4" socket w/drive ratchet
(1) 9/16" wrench Flashlig ht
When right or left hand is mentioned in this
manual, itmeans whenyou are intheoperating
position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
Remove all accessible loose parts and
parts cartons from carton,
Cut along dotted lines on all four panels
of carton. Remove end panels and lay
side panels flat.
Remove mower and packing materials.
Check for any additional loose parts or
cartons and remove,
BEFORE REMOVING TRACTOR
FROM SKID
TO CHECK BA'I-rERY
1. Lift hood to raised position.
NOTE: If this battery is put into service after
month and year indicated on label (label is
located between terminals) charge battery
for minimum of one hour at 6-10 amps. (See
"BATTERY" in Maintenance section of this
manual for charging instructions),
Forbatteryand batterycableinstallationsee
"REPLACING BATTERY" inthe"Service
and Adjustments" sectio n in this manual.
1. Sit in seat.
2. Lift up adjustment lever (A) and slide seat
until a comfortable position is reached
which allows you to press clutch/brake
pedal all the way down,
3. Release lever to lock seat in position,
NOTE: You may now roll your tractor offthe
s kid. Follow the instructions below to remove
the tractor from the skid.
_:_ WARNING: Before starting, read, un-
derstand and follow all instructions in the
Operation section of this manual. Be sure
tractor is in a welFventilated area. Be sure
the area in front of tractor is clear of other
people and objects.
TO ROLL TRACTOR OFF SKID (See
Operation
section for location and
function of
controls)
1. Raise attachment lift lever to _tshighest
position,
2. Release parking brake by depressing
clutch/brake pedal.
3. Place gearshift lever in neutral position.
4. Roll tractor forward off skid.
Continue with the Instructions that follow,
TO INSTALL MOWER
1. SET PARKING BRAKE LEVER AND
LOWER ATTACHMENT LIFT LEVER
Depress clutch/brake pedal all the way
down and hold.
Pull parking brake lever up and hold,
release pressurefrom clutch/brake pedal,
then release parking brake lever. Pedal
should remain in brake position. Ensure
parking brake will hold tractor secure.
\t
Brake Lever