Blodgett MT1820 Manual Del Usaurio página 8

Installation
Oven Assembly
CONVEYOR
1. Slide the conveyor assembly through the left
hand tunnel opening until the sprocket is in-
side the control box. See Figure 5.
2. Install the drive belt on the motor and then
around the pulley on the conveyor assembly.
See Figure 6. Pull the conveyor assembly
back to tighten the belt.
Figure 5
Figure 6
NOTE: To reverse the direction of the drive motor
(if necessary), exchange A1 and A2.
WARNING!!
Disconnect the power supply before re-
versing the drive motor.
CRUMB PANS
1. Install the crumb pans on both end of the con-
veyor.
6
Figure 7