Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Operation
1.
2.
3.
4.
5.
6.
Rivet Jaw Adjustment
1.
2.
3.
NOTE: Only turn jaw housing in 1/4 turn increments.
4.
5.
6.
Nose Cap
Jaw Case
Jam Nut
Figure 3
Connect the air tool to the air supply and cover the exhaust port with a
towel. Cycle the tool several times. Oil will discharge from the exhaust
port when air pressure is applied.
Size nose piece to appropriate rivet mandrel diameter.
Place rivet mandrel into nose piece.
Insert rivet shank into pre-drilled hole of materials to be riveted.
Squeeze trigger 1 to 2 times until rivet mandrel breaks off.
Tilt tool back until mandrel falls into safety cap.
Empty safety catch routinely.
Hold rivet gun with nose cap pointing away from self. Remove chrome
nose cap (See Figure 3).
Use a 15 mm wrench to hold the jaw case and a 17 mm wrench to loosen
the jam nut (See Figure 3).
Turn jaw case counter-clockwise making jaws tighten on rivet. Turn
clockwise to loosen jaws on rivet (See Figure 4).
Tighten jam nut.
Reassemble chrome nose cap.
Check function of rivet in tool. Re-adjust again if necessary
Turn jaw case
counterclockwise
to tighten jaws
on rivet
Figure 4
7
Turn jaw case
clockwise to loosen
jaws on rivet
Publicidad
Tabla de contenido
