First Time Setup; General Operation - HoMedics SC-325 Manual De Instrucciones

Thank you for your HoMedics Digital Scale purchase. This, like the entire HoMedics
product line, is built with high-quality craftsmanship to provide years of dependable
service. We hope you will find it to be the finest product of its kind.

First Time Setup

1. This scale operates on one lithium CR2032 battery (pre-installed). There is a plastic
strip under the lithium battery to prevent battery drain in shipping. Remove the strip
before continuing with these instructions.
2. Some models have a static cling label on the lens to prevent scratching.
Remove before use.
3. Set the "LB/KG/ST" unit of measure switch located on the back of the scale.
NOTE: The switch is pre-set to pounds.
4. The scale needs to be initialized before first use or after battery replacement. Press
lightly on the scale platform. The display will turn on, and automatically turn off. The
scale is now ready for use.
NOTE: The scale may need to be initialized if it is moved or bumped.

General Operation

1. Place the scale on a flat, hard surface. Carpeted or uneven floors may affect
accuracy. Be careful that the floor is not wet, or the scale may move.
2. Step on the scale, positioning your feet evenly on the scale platform (Figure 1). Use
caution so scale will not tip. Stand still while the scale measures your weight.
3. When your weight stabilizes, the display will show your weight. The weight reading
will remain on the screen for a few seconds. The display will turn off to conserve the
battery.
It is normal for your weight to fluctuate during the day and from one day to another.
Slight changes in your weight are normal. For best results:
1. Weigh yourself without clothing whenever possible. Clothes can vary in weight.
2. Weigh yourself at the same time of day under the same conditions.
3. Allow for weight fluctuations due to food or drink in your system.
Figure 1
2