juju Baby Boo Manual Del Usuario página 9

Step2. Put the two metal sections of the buckle connectors' together (fig. 2.1);
Slot the two buckle connectors into the slot in the top of the buckle until they "click"
into place (fig. 2.2)
Check the harness is correctly locked by pulling the shoulder straps upwards (fig.
2.3).
3.Tighten the shoulder harness
To release the harness (see point ADJUSTING THE SHOULDER HEIGHT), press the
red button on the buckle downwards.
SECURING THE INFANT CARRIER
Please read the operating handbook in your vehicle to inform yourself about the
basics concerning children's seats in vehicles.
DO NOT place this baby seat on seats with front airbags.
This baby car seat can only be installed using a three-point vehicle belt.
The baby car seat must be installed rearwards facing (in the direction opposite the
one in which you are traveling)
Step 1. Adjust the handle to the forward
seat. Handle must be firmly against the backrest of car's seat.
Step2. Slide the lap belt of the Vehicle's 3-point seatbelt through both Lap belt
guides. Let the tongue plate snap in the belt lock with a clearly audible "click". Pull
the shoulder belt in narrow
Pull the shoulder straps upwards to remove the whole
harness then pull the adjuster strap until the harness
is fully tightened (fig. left).
The harness should be adjusted as tightly as possible
with out causing discomfort to your child.
position (Fig. 3.1). Put the seat in car's
Page 9