Pahlen Jet Swim Motion Manual Del Usuario página 11

Jet Swim Motion
Installation
The pump section is installed on a stable surface in a dry area. Make sure that the area is well venti-
All installation of stainless steel parts shall be done using tools solely intended for such material
in order to maintain its corrosion-resistance. All screws should be lubricated with Molykote®
placement, see Fig 1.
See the Section entitled "Dimensions" for installation measures, placements etc.
N.B.!
The starting hose must be set in a loop 150-200 mm above the surface of the water.
Never run the pump dry. This will damage the axle seal.
Installation in thin pool wall with liner
(wood, sheet metal, plastic, etc.)
1.
3.
4. Install the pool liner with water up to 5 cm under the house.
5. Screw the clamping ring and the rubber gasket in place against the niche, 5 Nm in torque. The screws must be lubricated.
Cut away the pool liner against the inside of the clamping ring.
Connect the hose for the air admixture and tighten the hose clamp.
Attach the other opening of the hose 100 mm above the surface of the water behind the pool wall.
9.
10. Connect pipes and valves to the pump. All threads must be tightened with thread tape.
11.
Sample image: wooden frame with liner
1. Niche
3. Nut
5. Self-adhesive gasket
9. Inlet grate
10. Screw
11. Front
13. Pool framework
15. Liner
11
EN S
UP
A
Figure 1.
Recess seen from the front.
B
A