Enable Random (Stagger) Start - Peco Performance PRO School Serie Manual De Instrucciones

enable RanDoM (sTaGGeR) sTaRT

enable RanDoM (sTaGGeR) sTaRT enable RanDoM (sTaGGeR) sTaRT
Example: Selecting 5 assigns a random value
between 0 and 5 minutes within the actual start time.
i
note
An installation with more HVAC
:
units should select a higher max. start-
time offset, whereas an installation with
fewer HVAC units should select a lower
max. start-time offset.
© Copyright 2011. PECO, Inc. All Rights Reserved. P/N 70567 3220-2286 REV 00 05/11
PECO Performance PRO, School Series and the PECO logo are trademarks and/or service marks of PECO, Inc. The SD Logo is a trademark of SD-3C, LLC.
PRess anY KeY To beGIn
Random start greatly reduces the probability of
high peak electricity loads, avoiding potentially
high energy costs. Random start (only available
for School Schedule) applies to starting
equipment at specific event transitions.
1. Enter Service Menu 482. Select Option
01, 02, depending on power source.
2. Press Done. Return to Default Display.
3. Enter Service Menu 483 (Maximum
start-time offset), which refers to
time period in which random value is
generated.
4. Select preference: 3, 5,10,15, 30 min.
note: Default is 5.
5. Press ▲/ ▼to select the desired time.
6. Press Done. Settings are saved.
28