Connecting To A Bluetooth Device - Korg NC-Q1 Manual Usuario

Connecting to a Bluetooth device

Registering (pairing) this unit with a device
■
Pairing is required to connect this unit and a Bluetooth device in order to listen
to music or make a call.
1. While the unit is off, hold down the power button (
five seconds to enter pairing mode.
• The power indicator flashes alternately in blue and red, and the unit enters pairing
mode. After the unit has entered pairing mode, remove your finger from the power
button.
• If pairing with a device is not completed within five minutes, pairing mode will be
automatically cancelled.
2. Turn on the device to be connected to this
unit, and perform the pairing operation to
search for this unit.
• "NC-Q1" (the name of this unit) appears in
the device search screen of the device to be
connected to this unit.
• Place the device to be connected to this unit
within one meter.
• For details on the pairing procedure, also check
the manual of the device to be connected to
this unit.
3. Pair with the device to be connected to.
• Select "NC-Q1" (displayed in the device search screen) to establish a connection.
4. Check the connection status.
• The connection has been made when the power indicator on this unit flashes slowly.
10 NC-Q1 SMART NOISE CANCELLING DJ HEADPHONES
Connecting to a registered device
■
1. Turn on this unit.
2. Select this unit on the device to be connected to.
• Refer to steps 2 through 4 in "Registering (pairing) this unit with a device".
) for approximately
NOTE
• This unit remembers the last connected device. When this unit
is turned on, it may automatically connect to the last connected
device.
• A device that has been paired once does not need to be paired
again. However, if this unit can no longer connect to the device,
perform pairing again.