Publicidad
Idiomas disponibles
Idiomas disponibles
the holes. Then, install the wall bracket (2) with the corresponding self-tapping
screws (3).
Connect the wall bracket to the heating element (C) and fix the two elements
using the thumbscrew (5).
8 Usage
Keep the heater at an appropriate location and connect the device to a properly
installed 220-240V AC socket. By tipping the protective cage, you can change the
angle of inclination according to your needs.
Flip the switch (14) on the back of the control unit to "1" to activate the device. The
heating process is not yet complete! The device is initially in input mode.
By pressing the ON button on the remote control or the control panel, you can turn
on the first level. By pressing the "MODE" button, you can increase the level, or
reduce the level from the highest to the lowest. If you press the OFF button on the
remote control, the device is not switched off completely. It goes to a power-saving
standby mode and can be activated again at anytime.
Due to the tilt protection it switches itself off.
9 Cleaning
Pull out the power plug from the socket before starting with the cleaning process.
Use a slightly damp cloth for cleaning. The device should not be immersed in wa-
ter for cleaning under any circumstances. This could lead to electric shock or fire!
10 Safety instructions and liability disclaimer
Never try to open the device to carry out repairs or conversions. Avoid contact
with mains voltages. Do not short-circuit the product. The device is not certified
for use in the open air; only use it in dry conditions. Protect it from high humidity,
water and snow. Keep it away from high temperatures. Do not subject the de-
vice to sudden changes in temperature or heavy vibration as this might damage
electronic components. Examine the device for damage before using it. The unit
should not be used if it has received an impact or has been damaged in any other
way. Please observe national regulations and restrictions. Do not use the device
28
English
Publicidad
