Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Drill two holes in the wall. The holes should be:
●
At least 54mm / 2
/
" below the TV or 37mm / 1
1
8
soundbar). Add to this for greater spacing if desired
54mm / 2
●
727mm / 28
/
" apart (and level)
5
8
2.
Insert the anchors (unless screwing into wall studs); then screw in the screws (included) until they protrude from
the wall by 5–6mm / about
3.
Connect the included Toslink optical cable to the unit, and the 3.5mm cable too if you intend to use it. You can also
connect a USB extension cable (not included) to conveniently connect external USB devices to the unit
4.
Before hanging the soundbar on the wall, decide whether you need to route connected cables up or down.
According to this, either loop them over the top of the soundbar or allow them to hang down from the back so
they are ready to connect directly once the soundbar is mounted
5.
Align the keyhole mounting slot bracket holes on the rear of the unit with the screws. Hang the unit on the two
screws by slightly tilting the unit, pushing it onto the screws, and then lowering to slot in. Support the unit until you
are sure it's correctly and securely fitted
/
" above the TV (for 25mm / 1" distance between the TV and
7
16
⁄
"
1
8
727mm / 28
/
" (including screw head)
7
32
5–6mm / about
37mm / 1
/
"
5
8
/
"
7
32
- 04 -
⁄
"
7
16
Publicidad
Tabla de contenido
