Specifications; Installation Requirements - Wolf PRO ISLAND HOOD Guia De Instalacion

SPE C IF I CAT I O N S

Installation Requirements

Install the hood 30" to 36"
(762)
hood to the countertop.
B L OW E R A S S E M B L IE S
Pro Island Hoods require an internal, in-line, or remote
blower assembly, avail able through an authorized Wolf
dealer. For local dealer information, visit the find a show-
room section of our website, wolfappliance.com. Refer to
specific installation instructions provided with each blower
assembly.
D U C T C O VE R
Optional stainless steel duct covers, in multiple heights, are
available through your authorized Wolf dealer. For local
dealer information, visit the find a showroom section of our
website, wolfappliance.com.
4 | Wolf Customer Care 800.222.7820
from the bottom of the
(914)
Ducting
WARNING
To reduce the risk of fire, use only metal ducting.
IMPORTANT NOTE: Consult a qualified HVAC professional
for specific installation and ducting applications.
Pro Island Hoods accommodate a 10"
only rigid metal ducting.
A straight, short duct run allows the hood to perform most
efficiently. If the duct run exceeds 50'
blower may be required to maintain proper air flow.
Internal and in-line blowers require a roof or wall cap.
Connect ducting to the cap or to the remote blower and
work back towards the hood. Use sheet metal screws and
high-temperature duct tape to seal joints between ducting
sections.
Pro Island Hoods include a backdraft damper. Local codes
may require the use of an additional backdraft and/or make-
up air damper. Contact your local HVAC professional for
specific requirements.
A make-up air damper is available through an authorized
Wolf dealer. For local dealer information, visit the find a
showroom section of our website, wolfappliance.com.
round duct. Use
(254)
, a higher CFM
(15 m)