Hood Preparation; Installation - Wolf PRO ISLAND HOOD Guia De Instalacion

IN S TA L L AT I O N

Hood Preparation

Remove the filters prior to installation. To remove, press
the filter upward and rotate the bottom. Remove the grease
cups from the bottom edge of the hood. Refer to the illustra-
tion below.
GREASE
CUP
SPRING
FILTER
SIDE VIEW
Filters
6 | Wolf Customer Care 800.222.7820

Installation

WARNING
Ceiling framing must be able to support the weight of
the hood and internal blower, if applicable.
Refer to the illustration below for typical ceiling framing.
1
Additional framing or blocking is required in the
mounting location of the hood.
Drill four 5 / " diameter holes in the ceiling framing to
(4)
2
32
match the mounting holes in the corners of the hood's
top plate.
TOP PLATE WIDTH
13"
(330)
BLOCKING
Ceiling framing (typical)
C L
MOUNTING
HOLE