Filter Replacement; Installation Instructions - 3M Aqua-Pure AP Easy Manual De Instalación Y Operación

Change this filter at least every six months. Local water conditions and actual volume of water can affect filter life.
Replace if a noticeable drop in pressure occurs at the faucet.
For Use With Cold Water Only.
NOTE: Remove items from under the sink. Place catch basin there to
collect small amounts of water that may run out when disconnecting
water supply lines.
1. Turn off cold water supply valve and remove existing water
supply tubing and/or fitting.
2. Select and mark a location under the sink that allows access for
filter change.
3. Using filter head/bracket as a guide, fasten Filter Head Assembly to
wall with #2 Phillips mounting screws supplied.
Mark hole locations so that there is 1 1/2" between the screws
(see Figure 1), from center of each screw. When installed,
filter bottom should be at least 2 1/2" from sink cabinet floor
to facilitate cartridge change. Install screws, but only halfway,
so you can easily slip the bracket to wall before firmly setting
screws.
4. Determine length of tubing required from filter head/bracket
to faucet and from water supply line to filter head/bracket by
holding tubing in place ensuring it is of appropriate length.
Do not kink tubing as this will impede water flow. If necessary,
loop tubing around to avoid it being kinked.
Cut tubing straight with a utility knife. (See Figure 2).
5. Install faucet adapter fitting to faucet. This should be a snug fit.
Do not overtighten. (See Figure 3)
"Using Push-In Fittings"
To Attach Tubing
Push tubing in as far as it will go. Tubing must be inserted
past o-ring and hit backstop. Pull tube to ensure it is secured.
To reduce the risk associated with property damage due to water leakage or flooding:
• Ensure all tubing and fittings are secure and free of leaks.
FILTER REPLACEMENT
INSTALLATION INSTRUCTIONS
NOTICE
Backstop
Correct
Install Faucet
Adapter Fitting
To Release Tubing
Push in grey collet to release tubing. With collet
held, pull tubing straight out.
Collet
Figure 1
Incorrect
Figure 2
Figure 3