Carton Contents; Install Wheel Kit - Briggs & Stratton Generac PowerBoss 5500 Watt Storm-Plus Manual Del Usuario

Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-800-270-1408.
IMPORTANT: Any attempt to run the unit before it has
been serviced with the recommended oil will result in an
engine failure.
REMOVE GENERATOR
FROM CARTON
• Set the carton on a rigid flat surface with "This Side Up"
arrows pointing upward.
• Carefully open the top flaps of the shipping carton.
• Cut down corners at one end of carton from top to
bottom and lay that side of carton down flat.
• Remove all packing material, carton fillers, etc.
• Remove the generator from the shipping carton.
Figure 2 — Install Wheel Kit
Handle Assembly
Hex nut
Mounting Leg
Use Existing Fasteners
Downloaded from https://needmanual.com/
PowerBoss 5,500 Watt Storm-Plus Generator
Cap Screw
4

CARTON CONTENTS

Check all contents. If any parts are missing or damaged, call
the generator helpline at 1-800-270-1408.
• The generator
• Generator and engine owner's manuals
• Locking 30 Amp plug
• Engine oil
• Wheel kit

INSTALL WHEEL KIT

IMPORTANT:This wheel kit is not intended for
over-the-road use.
To install your wheel kit you need the following tools:
• Two 13mm box, open end, or socket wrenches
Install Wheel Kit as follows:
1. Place the bottom of the generator cradle on a flat,
even surface.Temporarily place unit on blocks to ease
assembly.
2. Slide axle through both axle mounting brackets on
cradle frame, as shown in Figure 2.
Axle
Wheel
Retaining Pin
Flat Washer