Clarity AlertMaster AL12 Guia Del Usuario página 5

INSTALLATION
The AlertMaster AL12 Remote Receiver is designed to work only
with the AlertMaster AL10 and AL11. The AlertMaster AL10 and
AL11 Notification systems are designed to work with as many
AlertMaster AL12 Remote Receivers as desired, placed up to 80
feet away from the base unit. For best reception, keep the antenna
in an upright position.
7
OPERATIONS
The AL12 console has six indicator lights for each of the alerting
functions of the AlertMaster Notification System. Some functions
require optional accessories to be purchased.
Any time the AlertMaster Remote Receiver is activated by any
function(s), it will reset automatically after two minutes, or you
can use the RESET button on top of the console. (The alarm
clock, however, is activated for one hour, not two minutes. It can
be shut off by pressing the SNOOZE or RESET / PAGE buttons
on the AL10, or the RESET button on top of the AL12 console.)
Refer to the AL10 User Guide's section on "Operations, Monitoring
Functions" for the lamp signaling pattern for each function.
Lamp Control
Press the center LAMP CONTROL button to turn the
AlertMaster AL12's lamp on and off. In order for the control to
work, ensure that the lamp is turned on prior to plugging the
lamp jack into the back of the AL12.
LAMP FLASHER ON / OFF
Use the LAMP FLASHER ON / OFF switch to turn the lamp
flashing function on or off. The lights on the front of the unit and
the Lamp Control remain active. The LAMP FLASHER ON / OFF
switch is located on the back of the unit, below the DIP switch
rubber cover.
E
N
G
L
I
S
H
8