Smartsense With Powerfoil - BIG ASS FANS SmartSense Guia De Instalacion

SmartSense with Powerfoil

Refer to the diagram below for the general installation of a SmartSense with Powerfoil X 2.0 and Powerfoil X 2.0 Plus
fans.
Note: The Powerfoil X2.0/Powerfoil X2.0 Plus wall controller and the SmartSense wall controller do not have to
be mounted adjacent to one other; each device is wired independently. Wiring for both wall controllers can be
routed in the same conduit.
F
H
U
RUN STOP FWD REV REM LOC
LOCAL
MODE
PU
REM
FWD PROG
REV DATA
STOP
RUN
RESET
INSTALLATION
Ceiling-mounted Upper
Temperature Sensor
10% FAN SPEED 100%
SmartSense Wall Controller
55°F THRESHOLD TEMPERATURE 100°F
(mounting plate not shown)
WINTER MODE
SUMMER MODE
MANUAL
MODE
WWW.BIGASSSOLUTIONS.COM
X2.0 and Powerfoil X2.0Plus fans
®
© 2015 DELTA T CORP. ALL RIGHTS RESERVED.
PowerfoilX2.0 or
PowerfoilX2.0 Plus Fan System
7