Luggie Smart Fold Manual De Instrucciones Para El Usuario página 42

incorrect installation of connectors when assembling the scooter after transporting
the scooter. If your Luggie scooter fails to operate refer to the status fault codes on the
following page for reference. If in doubt, consult the dealer from whom you purchased
your Luggie scooter.
DO NOT OPEN THE BATTERY HOUSING. BREAKING THE BATTERY SEAL
VOIDS THE WARRANTY AUTOMATICALLY!
SPEED CONTROLLER SETTINGS
Warning: Performance adjustments should not be made to the wig wag levers which
could compromise the integrity of the speed controls and put the operator in a serious
danger. Performance adjustments should ONLY be made by an Authorized Luggie
technician fully trained and conversant with the programming and capabilities of the
Luggie scooter.
Warning: Incorrect settings could cause injury to the scooter operator and/or to
bystanders or damage to the scooter and/or surrounding property. If in doubt, consult your
local dealer.
STATUS FAULT CODES
FLASH
1 Battery Low
2 Low Battery Fault
3 High Battery Fault
4 Current Limit Time-out
37
Description
The battery is running low. Recharge the battery
The battery has run out of charge. Recharge the
battery.
Battery voltage is too high. This may occur if
overcharged and/or traveling down a long slope.
When traveling down a slope, reduce your speed to
minimize the amount of regenerative charge. Check
the battery and associated connections and wiring.
The motor has been exceeding its maximum current
rating for too long. This may be due to a faulty
motor. Check the motor and associated connections
and wiring. Turn the controller off. Let it stand for a
few minutes before powering it back on again.
Meaning