Premium PBO6500A Manual De Uso Y Cuidado página 6

Installation
WARNING!
Please follow the points below when installing the appliance
Hire an authorized technician
No alterations or changes in the electricity supply
should be carried out.
Connections diagram
connection box's
connection wire should match the connection
type and oven's power rating.
Refer to data plate for rating information. The
data plate is located on the side of appliance.
Connection cable must be secured with a
strain-relief clamp.
A safety circuit must be connected to the terminal
marked with in connection box.
A means of disconnection with a contact
separation of at least 3mm must be supplied in
the fixed wiring.
Disconnect the appliance's power plug from the
power terminal during maintenance or repairs.
This Appliance
Grounded
Do not lift the appliance by the door handles.
Prepare the cabinet opening to match your
appliance measurements. (See diagrams).
Slide appliance in to cabinet cavity, ensuring
supply cable is not obstructed (kinked, jammed
or twisted).
To prevent tipping or dislodging of the appliance,
secure appliance to the cabinet with 4 screws
(provided), through the holes in the appliance
frame.
The cabinet material, where the appliance is built
into, must be capable of withstanding 70°C.
Installation into
cabinetry (E.g. vinyl coated) may result in
deterioration of coating by discoloring or
bubbling.
The cabinet panels to the oven must be heat
resistant. With veneered wood units, glues must
resist up to 100°C.
If the appliance is to be installed adjacent to vinyl
is located on
cover. Remember
Must Be Properly
low temperature tolerant
wrapped surfaces, use an installation kit
available from the vinyl-wrap supplier.
We cannot accept responsibility for damages
the caused by installation into low temperature
that tolerant cabinets.
After installation, test and ensure the appliance
operates correctly before handing it over to the
customer.
CAUTION!
Where the appliance is connected via power supply
cable to a power point, the installed power point must
remain accessible after appliance installation
A dedicated power circuit is recommended for the unit
but not required. Additional electrical appliances on
the same circuit may exceed the current (amperage)
rating for that circuit. If after the installation of your
unit the circuit breaker trips or the fuse fails on a
repeated basis, then a dedicated circuit will likely be
required.
WARNING!
To avoid any potential hazard, you must
follow our instructions during installation.
Failure to install the appliance correctly
could invalidate any warranty or liability
claims and lead to prosecution.
5