Publicidad
Installation Instructions
Attach SSBU/SSMU to RPA or RPM
1.
On SSBU, partially install four thumb nuts (D) to SSBU main
plate screws. (See Figure 8)
1
(D) x 4
(A)
Figure 8
2.
Place SSBU/SSMU base plate (B) over SSBU/SSMU
interface plate (A). (See Figure 9)
2
(A)
Figure 9
3.
Attach SSBU/SSMU to RSA/RSM. Refer to RSA/RSM
installation manual for details.
Security Screw Installation (Optional)
1.
Install #8-32 x 3/8" button head security screws (F) into
security holes on SSBU/SSMU legs. (See Figure 10)
NOTE:
Up to two security screws can be installed on each leg.
It is recommended that screws be installed in holes that
are difficult to access to achieve maximum security.
NOTE:
(C)
(B)
Cable ties (not included) may be used instead of the
security screws. Thread cable tie through both holes on
leg and secure cable tie.
1
security hole
Figure 10
SSBU/SSMU
(F)
9
Publicidad
