Operation: Air Bath - American Standard 2742 Manual De Instalación Y Funcionamiento

BATHING:
• IMPORTANT: DO NOT ADD BATH OILS OR SALTS as they will damage the whirlpool pump and may
harm the acrylic surface.
• Close drain by rotating Drain Overflow Knob COUNTER-CLOCKWISE
• Fill bath with water at a comfortable bathing temperature.
OPERATING AIR MASSAGE SYSTEM:
EXITING THE BATH
• Be sure to turn off the air blower before draining bath.
• Open drain by rotating drain knob clockwise.
STANDARD DRYING CYCLE
An automatic drying cycle will start 20 minutes after the blower is turned off. The blower LED blinks while waiting for the
purge cycle.
24H PROGRAMMABLE DRYING CYCLE
The system must be stopped prior to activation or deactivation.
Activation: Determine at which time you wish to purge to activate. At that precise time, press and hold the second button on
the keypad for 5 seconds, all LEDs will flash twice. The purge cycle will now start at the programmed time every 24 hrs. In
the event of a power failure, the program will be automatically deactivated.
Deactivation: Press and hold the second button on the keypad for 5 seconds, all LEDs will flash once to confirm deactivation.

Operation: Air Bath

ON/OFF:
Press this button once to turn air-blower on.
Press again to turn air-blower off.
AIR SPEED INCREASE:
Pressing this button will increase to the next higher speed.
AIR SPEED DECREASE:
Pressing this button will decrease to the next lower speed.
WAVE FUNCTION:
Press this button to start the wave function (button will light).
Blower speed will continuously vary between high and low.
Press again to exit wave function (button light will go out).
DRYING CYCLE OPTIONS
28
754532-100 Rev. 3 3/19