FTE Maximal ATLAS Manual De Instalación Rápida página 17

2.2. Connections
1 RF IN: Input signal (DVB-S/S2, DVB-T/T2, DVB-C). The RF input can supply remote
device as LNB or mast amplifier.
2 MIX: The input mix of the RF output of the transmodulator, allow feeding remote power
for another Atlas device too. (Remember if this input is not used connect a load 75 Ω
isolated).
3 Ground connector.
4 CI: CAM INTERFACE Slot.
5 RF OUT: This is the output connector of the modulator. The output mux will be mixed
with all terrestrial signal received in the input MIX. This output could be used too as
remote input power supply when the output cable is connected to the MIX connector of
another ATLAS device.
6 STATUS: When the light is on, the tuner is lock. The light is blinking when the
transmodulator is programming with the web interface
7 LOOP-OUT: Is possible connect in this output to the RF input of another Atlas device to
get the signal received. (Remember if this output is not used connect a load 75 Ω
isolated).
8 DC IN: Connector for the external power supply 15V.
9 LED POWER: Led is a power indication of the transmodulador. The color is red when the
device is booting. When the device is ready to programming or it is ready to work the led
will be green.
10 Reset 1s/ F. Default 8s: Pressing and hold this button 1 second the device will be
reboot. If press and hold at least 8 second the device load the factory default values and
reboot.
11 LAN: Allow programming the device using the web interface and it is the IP streams
output.
Reservado el derecho para modificaciones técnicas y/o errores
Quick installation Guide ATLAS
3
- -
ATLAS Versión en_10 Fte maximal