Powering On The Printer; Power Cords - Genicom 38XX Serie Una Guía Rápida De Referencia

If the voltage needs to be changed
Power ON/OFF Switch
Power
Receptacle

POWERING ON THE PRINTER

Power Cords

Quick Reference Guide
Use a slender object such as a paper clip that has been
straightened. When setting the printer for 115V, while power
switch is off, slide the switch to the left so it shows 115V. While
power switch is off, slide it to the right for 230V operation.
Voltage Selector Switch
Do not use two-wire extension cords or adapters that allow
connection to ungrounded outlets.
A 6.5-foot power cord is shipped with the printer. The power cord
included with printers sold for 115V installations in the U.S. and
Canada is ready to use. International model printers are shipped
with a power cord which can be used in a number of European
countries.
For units to be operated at 115V, use a UL Listed/CSA Certified
three-conductor cord set, #18 AWG minimum, Type SVT or SJT.
The maximum length is 15 feet. There must be a NEMA 5-15P
(parallel blade, grounding type) plug on one end and a CEE 22/5
socket on the other end. The cord set should be rated 10A, 250V
and have a grounding plug with safety approvals appropriate for
the country in which the equipment will be installed.
For units to be operated at 230V inside U.S. and Canada, use a
UL Listed/CSA Certified three-conductor cord set, #18 AWG
minimum, Type SVT or SJT. The maximum length is 15 feet.
There must be a NEMA 6-15P (tandem blade, grounding type)
plug on one end and a CEE 22/5 socket on the other end. The
cord set should be rated 10A, 250V and have a grounding plug
with safety approvals appropriate for the country in which the
equipment will be installed.
Voltage Selector
Switch
4
GEK-89604