Loading Paper/Form - Genicom 38XX Serie Una Guía Rápida De Referencia

Seat the cartridge on the ribbon drive spindle.
Snap the ribbon cartridge down on the supports.
Ribbon
Advance
Knob
Turn the ribbon advance knob clockwise to make sure the ribbon is taut.
Slide the print head back and forth...

Loading Paper/Form

Quick Reference Guide
Lay the cartridge down in the printer about where it should go
and wiggle it around until the ribbon drive spindle slips up into
the hub of the cartridge. Turn the ribbon advance knob clockwise
and feel the ribbon drive gears turning in the printer.
There are snaps on the bottom of the cartridge at the rear
corners. These snap onto corresponding posts in the printer.
Gently push the rear corners of the cartridge down at both ends
until the snaps snap into place.
Support
Adjusting the Ribbon Advance Knob
Verify that the print head moves smoothly without binding or
snagging the ribbon.
Each printer is shipped with a set of tractors installed in the rear.
A second set of tractors is packed in a box for installation in the
front/bottom paper path. The procedure for loading sprocket-feed
paper is the same for the rear, front, or bottom paper paths.
The tractor that holds the left edge of the paper will be referred to
as the home-position tractor. The other tractor will be called the
far tractor.
It is necessary to adjust the location of both tractors in order to:
•
Fit the width of paper being used.
•
Position left side of paper to proper left margin print position.
9
Foot
GEK-89604