Important Safety Warnings; Risk Of Electric Shock Or Electrocution - Mi-T-M Corporation MV-1300-0MEV Instrucciones De Operación

WARNING: When using this product, basic precautions should always be observed, including the following:
READ ALL SAFETY INSTRUCTIONS BEFORE USING WET/DRY VAC
HAZARD
RISK OF ELECTRIC SHOCK
OR ELECTROCUTION
4
SAFETY WARNINGS
POTENTIAL CONSEQUENCE
Serious injury or death could occur
if the Wet/Dry Vac is not properly
grounded. Your Wet/Dry Vac is
powered by electricity and may
cause electric shock or electrocution
if not used properly.
Electrical shock may occur from
electrical cord.
Serious injury or death may occur if
electrical repairs are attempted by
unqualified persons.
PREVENTION
This product must be grounded. Connect to a
properly grounded outlet only. See "Grounding
Instructions".
Always be certain the unit is receiving proper
voltage. Before plugging the unit into a
compatible power source, be certain the switch
is in the "OFF" position. Disconnect when not
in use.
Do not modify plug provided with the product.
If it will not fit the outlet, have a proper outlet
installed by a qualified electrician. Do not remove
the plug or use any type of adapter.
Do not expose the Wet/Dry Vac to rain or
submerge in water. Do not use pressurized water
to clean the Wet/Dry Vac. Store indoors.
Check power cord for signs of crushing, cutting
or heat damage. If replacement of plug or cord is
needed, use only identical replacement parts.
If Wet/Dry Vac is not working correctly, has been
dropped, damaged, left outdoors, or dropped
into water, return it to a service center.
Keep all connections dry and off the ground. Do
not allow electrical cords to lay in water or in such
a position where water could come in contact
with them. Do not handle plug or Wet/Dry Vac
with wet hands.
Do not pull or carry the unit by the electrical
cord. Do not use the cord as a handle, close a
door on cord, or pull cord around sharp edges
or corners. Do not run Wet/Dry Vac over cord.
Keep cord away from heated surfaces.
Turn off all controls before unplugging the unit
from the outlet. Do not unplug by pulling on cord.
To unplug, grasp the plug, not the cord.
Use only extension cords having an electrical
rating not less than the rating of the product. Do
not use damaged extension cords. Examine
extension cord before using and replace if
damaged. Keep cord away from heat and
sharp edges. Always connect and disconnect
the extension cord from the receptacle before
connecting and disconnecting the product from
the extension cord.
Any electrical wiring or repairs performed on
this Wet/Dry Vac should be done by Authorized
Service Personnel in accordance with National
and Local electrical codes.
Before opening any electrical enclosure, always
shut off the Wet/Dry Vac and unplug the Wet/Dry
Vac from the power source. Allow the Wet/Dry
Vac to cool down. Service in a clean, dry, flat
area.
Wet/Dry Vac Operator's Manual