Technical Specifications - Metabo RWE 1020 Manual Original

en ENGLISH
7.4 On/Off switch, modifying the speed
Switching on, speed: Press the trigger (3) .
Press in the trigger to increase the rotational speed.
To switch off release the trigger switch.
Continuous operation: With the trigger (3)
pressed, push in the locking button (4) and release
the trigger. Press and release the trigger (3) again to
switch off.
In continuous operation, the machine
continues running if it is forced out of your
hands. Therefore, always hold the machine with
both hands using the handles provided, stand
securely and concentrate.
7.5 Switching on/off, change speed (for
cordless machines)
Press locking button (7) and keep pressed, then
press the trigger (3).
Press the trigger (3) to increase the rotational
speed.
To switch off release the trigger switch.
8. Cleaning
Clean the machine regularly.
9. Troubleshooting
9.1 Mains powered machines:
- Overload protection: There is a MAJOR
reduction in load speed. The motor temperature
is too high! Allow the machine to run at idle speed
until it has cooled down.
- Overload protection: There is a SLIGHT
reduction in load speed. The machine is
overloaded. Reduce the load before continuing to
work.
- Restart protection: The machine does not
start. The restart protection is active. If the mains
plug is inserted with the machine switched on, or if
the power supply is restored following an
interruption, the machine does not start up. Switch
the machine off and on again.
9.2 Cordless machines:
Overload protection: The machine has shut
down by itself. The device is too hot! Allow the
machine to run at idle speed until it has cooled
down.
ENG
10. Accessories
Only use original Metabo battery packs and Metabo
accessories.
Battery packs with different capacities. Use battery
packs only with voltage suitable for your power tool.
Use only accessories which fulfil the requirements
and specifications listed in these operating
instructions.
See www.metabo.com or the catalogue for a
complete range of accessories.
10
11. Repairs
Repairs to electrical tools must ONLY be carried out
by qualified electricians!
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. See
www.metabo.com for addresses.
You can download a list of spare parts from
www.metabo.com.
12. Environmental Protection
Observe national regulations on environmentally
compatible disposal and on the recycling of disused
machines, packaging and accessories.
Only for EU countries: Never dispose of
power tools in your household waste! Used
power tools must be collected separately and
handed in for environmentally compatible recycling
in accordance with European Directive 2002/96/EC
on waste electrical and electronic equipment and its
implementation in national legal systems.
Special notes regarding cordless machines:
Battery packs may not be disposed of with regular
waste. Return faulty or used battery packs to your
Metabo dealer!
Do not allow battery packs to come into contact with
water!
Before disposal, discharge the battery pack in the
power tool. Prevent the contacts from short-
circuiting (e. g. by protecting them with adhesive
tape).

13. Technical Specifications

Explanatory notes on the specifications on page 3.
Changes due to technological progress reserved.
P = Rated input
1
P = Power output
2
n = No-load speed
0
n = On-load speed
1
G = Drill spindle thread
D = maximum permitted agitator diameter
R
D = Collar diameter
m = weight with smallest battery pack/weight
without cord
Measured values determined in conformity with
EN 60745.
Machine in protection class II
~
AC Power
Direct current
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on the operating conditions, the
condition of the power tool or the accessories.
Please allow for breaks and periods when the load