Light Bulbs; Install The Filter - NuTone AHSA1 Serie Manual De Instalación, Uso Y Cuidado

Light Bulbs

This range hood requires two shielded halogen bulbs (120 V, 50 W max., MR16 or PAR16 with
GU10 base), included.
NOTE: Before using lamps, remove shipping tape on them (if present).
Do not touch lamps during or soon after operation. Burns may occur. In order to prevent
the risk of personal injury, only install shielded halogen lamps. Also, never install a cool
beam, a dichroic lamp, a lamp not suitable for use in recessed luminaires or identified for
use in enclosed fixtures.
BULB LEADS
1 ] Align the bulb leads with the small indentations located on the border of the lamp location on
hood (see inset above), then install the bulbs by placing the bulb leads into their grooves in
the socket.
2 ] Gently push upwards and turn clockwise until secure.
NOTE: The Suction Cup Tool (included with hood) can be used to install and remove light bulbs.
Press suction cup tool on bulb and rotate counterclockwise to remove bulb or clockwise
to install bulb.
Most GU10 LED replacement bulbs commonly found in the market are not designed
for use in a cooking environment and might not perform as advertised. Their usage
with this product is not recommended.

Install the Filter

Ducted Installation Only:
Re-install grease filter removed in step 2 on page 9 under "Prepare the Hood" .
Non-ducted Installation Only:
Purchase one non-ducted filter from your local distributor or retailer (see product specification
label inside of hood for filter type and part number). Attach the non-ducted filter following
instructions packed with the non-ducted filter.
!
WARNING
BULB LEAD
GROOVES
(IN SOCKET)
INDENT
! CAUTION
SUCTION
CUP TOOL
15