Grounding Instructions - Best P195ES70SB Manual De Instrucciones

WIRING
Note: This range hood must be properly
grounded. The unit should be installed by
a qualified electrician in accordance
with all applicable national and local
electrical codes. The grounded 3 prong
outlet should be accessible after the
hood installation (i.e.: access door).

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the
event of an electical short circuit,
grounding reduces the risk of electric
shock by providing an escape wire for the
electric current. This appliance is equipped
with a cord having a grounding wire with a
grounding plug. The plug must by plugged
into an outlet that is properly installed and
grounded.
WARNING - Improper grounding can
result in a risk of electric shock.
Consult a qualified electrician if the
grounding instructions are not completely
understood, or if doubt exist as to wheter
the appliance is properly grounded. Do not
use an extension cord. If the power supply
cord is too short, have a qualified electrician
install an outlet near the appliance. Position
the power socket at a maximum distance
of 33-7/16" (85cm.) from where the lead
exits from the hood (see illustration
alongside). Fit the plug into the power
socket.
INSTALL THE HOOD
Note: The hood must be installed inside
the cabinet.
The internal height of cabinet must be
minimum 16".
The hood should be mounted centered
over the cook top burners.
1. Remove the frame by moving the 2
slide fasteners "A" forward (Fig.4 ).
Push the filter latch and tilt the filter
downward (B) and remove.
2. Cut a hole in the bottom of the cabinet,
using the dimensions shown (Fig.5 ).
3. Adjust the position of the clasping side
spring by turning the "D" screw
according to the thickness of the
cabinet to which it is going to be
anchored (Fig.6).
4. Insert the hood in the cabinet (Fig.7 )
and lock into position using the side
spring.
5. Secure the hood with (4) "C" mounting
screws.
6. Replace the frame by moving the 2
slide fasteners "A" backward. (Fig.4 ).
HOOD
CLASPING SIDE
SPRING
X
X
= min 7/16"
max 13/16"
CONNECT DUCTWORK
1. Use 8" round metal duct to connect
the duct connector on the hood to the
ductwork above.
2. Use duct tape to make all joints secure
and air tight.
- 7 -
33-7/16"
(85cm.)
MAX.
10-¼"
1"
26-9/16
D
Fig. 4
Fig. 5
Fig.6
Fig.7