Install Filters - Best P195ES70SB Manual De Instrucciones

INSTALL FILTERS

(NON-DUCTED HOODS ONLY) - Fig.8
1. Install a charcoal filter on each side of
the blower (included with Non-ducted
Charcoal Filter Model: ROUNDFILTER
2. To install the charcoal filter, align center
keyhole slot on the filter with center of
the blower. Rotate to lock filter into place.
3. To remove the charcoal filter, rotate the
filter until it disengages from the blower.
(DUCTED AND NON-DUCTED HOODS)
•
To remove the GREASE filter, grip the
latch tab and pull it down. This will
disengange the filter from the hood.
•
To install the GREASE filter, align filter
tabs to the side of the filter with slots in
the hood drawer. Pull latch tab down,
push filter up into place and release the
tab.
• Make sure the filter is securely
enganged after assembly.
MAINTENANCE
ALWAYS SWITCH OFF THE ELECTRICITY
SUPPLY BEFORE CARRYING OUT ANY
OPERATIONS ON THE APPLIANCE.
Grease Filters
The grease filter should be cleaned fre-
quently. Use a warm detergent solution.
Grease filter is dishwasher safe.
To remove the grease filter: push in on the
metal latch tab. Tilt the filter downward and
remove.
Cleaning
Occasional care will help preserve its fine
appearance.
• Clean with warm water and mild detergent
only.
• Follow all cleaning by rinsing with clear
water.
• Wipe dry with clean, soft cloth.
Light bulbs
This range hood requires two 13 watt
G24q-1 Compact Fluorescent lamps
(included). To change bulbs (Fig.9):
1. Remove the frame by moving the 2 slide
fasteners (A) (Fig.4, page 6).
2. To replace lamp, grasp lamp at base and
pull out to remove. Replace with 13W
Fluorescent lamp noted above.
CAUTION: BULB MAY BE HOT!
RECIRCULATION FILTERS
OPERATION
Controls
The light switch turns the lamps on
and off.
The blower switch: makes it possible
to select the motor operating speed
(3 speeds).
Position 0: motor off.
The pilot lamp lights up whenever the
blower is on.
LIGHT
SWITCH
0 1
PILOT LAMP
- 8 -
NON-DUCTED
Fig.8
Fig.9
- Fig.10
BLOWER
SWITCH
0 1 2 3
Fig.10