Package Contents; Factory Default Settings - Atlantis ADSL2+ Guia De Inicio Rapido

ENG
Thank You for choosing an Atlantis Product. For more detailed instructions on configuring and using the CamRouter
please refer to the online manual on the CD-Rom.
1.1

Package Contents

Unpack the package and check all the items carefully. Also, keep the box and packing materials in case you need to
ship the unit in the future. The package should contain the following items: Wireless N ADSL2+ Router, Power
Adapter AC/DC (12V, .8A), UTP cat. 5 cable (RJ-45 connector), Phone cable (RJ-11 connector), ADSL RJ11 Filter,
Quick Start Guide (English, Italian, French and Spanish), Cd-Rom with manual(English and Italian) and Warranty
Card.
If any item is found missing or damaged, please contact your local reseller for replacement.
1.2

Factory Default Settings

Before you configure this Router, you need to know the following default settings:
 Username: admin
 Password: atlantis
 IP address: 192.168.1.254
 Subnet Mask: 255.255.255.0
 WAN=PPPoE, LLC/SNAP Bridging, VPI=8, VCI=35
 ESSID= A02-RA145-W300N/A02-RA145-WN, Channel=Auto, WEP/WPA=WPA2-PSK (AES)
 WPA Pre-shared Key: WebShare145WN
 DHCP Server: enable (from 192.168.1.100 to 192.168.1.200)
1.3 Cabling
First you must connect the product to the ADSL line through the RJ11 cable you have in equipment (in the port DSL),
then connect to the RJ45 ports the PCs of your Lan or others Switch. You can get to the Wireless Router through the
different wireless client compatible with the IEEE 802.11b/g/n standard. Connect the AC-DC Adapter to the Wireless
ADSL2+ Router and then to the socket. Once you've checked all the connections and you've switched on the Wireless
ADSL2+ Router the product will carry on immediately a autotest (60 seconds). Finished this, the LEDs status will be
the following:
LED
PWR
DSL
INTERNET
LAN 1-4
USB
WLAN
WPS
The Led ADSL, if suitably connected, at first will be flashing and then it will remain fixed.
One of the most common causes of problem is bad cabling or ADSL line(s). Make sure that all connected devices are
turned on. On the front panel of your router is a bank of LEDs. Verify that the LAN Link and ADSL line LEDs are lit. If
they are not, verify if you are using the proper cables. Make sure that all devices (e.g. telephones, fax machines,
analogue modems) connected to the same telephone line as your router have a line filter connected between them
and the wall outlet (unless you are using a Central Splitter or Central Filter installed by a qualified and licensed
electrician), and that all line filters are correctly installed in a right way. If line filter is not installed and connected
properly, it may cause problem to your ADSL connection or may result in frequent disconnections.
After the device has turned on, press it to reset the device or restore to factory
default settings. The operation is as below:
 6 seconds or above: restore to factory default settings (this is used when
you can not login to the router, e.g. forgot the password)
Lit green (the device is powered on and the device operates normally)
Lit Red (the device is loading the FW)
Lit green
OFF
Lit or Blinking green if any device is connected to the Router
OFF
Lit or Blinking green if any device is connected to the Router
OFF
If the ADSL Led flashes periodically, click on Advanced Setup, then DSL.
Choose ADSL modulation, then click on Apply/Save.
Status
11
ENG