Filling The Water Tank - Black+Decker HGS310 Manual De Uso Y Cuidado

FILLING THE WATER TANK

1. Place the steamer on its base on a stable surface.
2. Hold the handle to stabilize and pull out the removable
water tank with the other hand. (E)
3. Gently pull out the rubber water tank cover at the top
of the tank. (F)
Tip: Using distilled, purified, or filtered water is highly
recommended and will reduce mineral buildup. Do not use
oils, perfumes, or scented additives.
4. Using a clean measuring cup, pour water into opening
until water reaches the "MAX" level mark on the top
of the tank. (G) Do not overfill. Close the rubber cover
securely.
5. Dry off any excess water from the tank. Push water
tank back into the steamer base; click into place.
6. To refill at any time during use, turn steamer off by
pressing the power button until the blue indicator
light is off, unplug from outlet, and follow the above
procedure.
Tip: After refilling, allow to reheat for 45 seconds and then prime pump by
holding steam trigger until steam forms.
US IN G THE HA N DHE LD ST E AM E R
1. Read the manufacturer's fabric label to make sure the fabrics are
suitable for steaming.
• If you see "do not iron" or this icon
plate against the garment. Instead attach the delicate fabric frame
and make sure to test on an inconspicuous area prior to steaming
the entire garment.
• If you see "do not steam" or this icon
garment.
2. Refer to the "Attaching Frames" section for
determining whether to use a frame. Attach or remove
frames while the steamer and frames are cool.
3. Place the garment on a hanger and hang through one
of the fabric loops on the ironing pad. (H) Make sure
the garment is smoothed out and flat to the pad to
avoid steaming in wrinkles. Lightly stretch the fabric
with the provided clips to help keep it flat during
steaming. (I)
, do not press the ironing
, do not steam the
6
E
F
G
H
I