Black+Decker HGS310 Manual De Uso Y Cuidado página 7

• Use the ironing pad with the ironing plate to get crisp results.
• The steamer may be used without the pad by hanging the garment
in an area that will not be impacted by the heat and steam, such as
on a shower rod.
4. Plug the steamer into an outlet and then press the power
button. (J) The blue power button light will slowly blink,
indicating that the steamer is heating.
5. After about 45 seconds the power light will stay on,
indicating the steamer is preheated. The Ironing Plate
will be fully preheated in 1–3 minutes.
Note: The fixed temperature on the ironing plate is a mid-
range heat level
If the garment label says not to iron
temperatures
6. Prime the water pump by holding steam trigger until
steam forms.
7. To generate steam, press down on the steam trigger
with your index finger. (K) As long as the trigger is
held down, steam will emit from the steamer. When the
trigger is released, the steam will stop.
• To generate a constant flow of steam without holding
the trigger, press the steam trigger and then slide the
continuous steam switch down. (L) This will activate
the continuous steam feature. To turn the steam off,
press the trigger, push the continuous steam switch
up and then release trigger.
Note: It is normal to feel or hear the water pump in the handle.
8. To iron using the Ironing Plate with the ironing pad,
start steaming and then lightly press the metal ironing
plate against the garment on the ironing pad. (M) Drag
the ironing plate up and down the fabric, being careful
to keep hands away from the steam and never leaving
the plate in one section for too long; similar to how an
iron is used.
Note: If the steamer is left inactive, the auto shut-off
feature will activate, indicated by the rapidly blinking
Power Button. To resume steaming after the auto shut-off
is activated, either press the steam trigger or press the
power button. Allow the steamer to preheat if needed.
9. When finished steaming, press and hold the power button
until its blue light turns off (about 3 seconds) and unplug
from outlet. (N)
10. Stand steamer on its base and allow it to completely
cool off before storing. (O) To avoid mineral buildup, empty the tank
after each use.
, which is suitable for most fabrics.
, use the delicate fabric frame.
, or iron at low
7
J
K
L
M
N
O