Lan And Wlan Ports; Accessing The Access Point Web Configurator - Atlantis Land MIMO A02-AP2-W54M Guia De Inicio Rapido

If you lose password, press reset button for 15 (or more) seconds to restore
default setting to Wireless MIMO Multi-Function AP.
Press reset button until Wireless MIMO Multi-Function AP will reboot (LED
STATUS turn off); when STATUS blinking, release reset button. Now,
Wireless MIMO Multi-Function AP is restoring to factory setting.

1.12 LAN and WLAN Ports

The parameters of LAN and WLAN ports are pre-set in the factory. The default values
are shown below.
Porta LAN
IP address
Subnet Mask

1.13 Accessing the Access Point Web Configurator

Before you configure this device, note that when the Accessing the Access Point Web
Configurator is configured through an Ethernet connection, make sure the manager PC
must be set on same the IP network. For example, when the default network address
of the default IP address of the Accessing the Access Point Web Configurator is
192.168.1.254, then the manager PC should be set at 192.168.1.x (where x is a
number between 1 and 253), and the default subnet mask is 255.255.255.0.
Open Internet Explorer 5.0 or above Web browser.
Enter IP address http://192.168.1.254 (the factory-default IP address setting) to the
address location.
When there is a screen needs to enter the User name and Password, both of the
default Username is "admin" and Password is "atlantis".Click OK.
192.168.1.254
255.255.255.0
Porta WLAN
Mode=Access Point
Channel=6
SSID= A02-AP2-W54M
Security=Disabled
ENGLISH
32