Milnor 30015T5E Manual De Instrucciones página 27

Table 6: Bearings and Bushings. See
Mark
Do this each
1 2 3 4 5 6
x 600 hours
Table 7: Motor Grease Schedule. Use the data in
Motor Identification
(example: main drive)
Table 8: Mechanisms and Settings
Make sure mechanisms are serviceable and settings are correct to prevent unsatisfactory
Mark
Do this each
1 2 3 4 5 6
x 2400 hours
x 200 hours
Table 7 for Motors.
Apply grease to these components to prevent damage.
Component
bearing housing
Section 3.1.4.2
Interval Quantity
Years Hours fl oz
performance.
Component
controller circuitry
bath level sensor that uses air
pressure
23
Chapter 3. Routine Maintenance
More Data. See also
"Lubricant Identification and Procedures"
The bearing assembly is oil-filled. No routine
grease maintenance is required. Grease is
added to the seal grease cavity at assembly.
Examine the grease cavity drain tube
14). If a large quantity of contamination or
water flows from the tube, maintenance can
be necessary. Speak to your dealer or
Milnor.This is not routine maintenance.
to complete this table.
Dates When Grease is Added
mL
Examine wiring and connections in electrical
boxes. Look for corrosion, loose connections.
See Section 3.1.3
Examine the air tube and connections. See
Figure 11
PELLERIN MILNOR CORPORATION
Section 3.1.4
(Figure
.
More Data