Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TO CHECK
BRAKE
If tractor
requires
more than five (5) feet to
stop at highest
speed in highest
gear on a
level, dry concrete
or paved
surface,
then
brake must be serviced.
You may also check brake by:
!o Park tractor
on a level, dry concrete
or
paved surface,
depress
brake pedal all
the way down and engage parking brake.
2.
Disengage
transmission
by
placing
freewheel
control
in "transmission
dis-
engaged"
position.
Pull freewheel
control
out and into the slot and release so it is
held in the disengaged
position.
The rear wheels
must lock and skid when
you try to manually
push the tractor forward°
if the
rear wheels
rotate,
then the brake
needs to be serviced,
Contact
a Sears
or
other qualified
service center.
FRONT WHEEL
TOE-IN/CAMBER
"Your new tractor front wheel toe-in and cam-
ber is set at the factory and is normal. The
front wheel toeqn and cam ber are not adjust-
able. if damage
has occurred
to affect the
factory set front wheeltoe-in
or camber, con-
tact a Sears or other qualified
service center.
TO REMOVE
WHEEL
FOR REPAIRS
i,
Block up axle securety_
2.
Remove
axle cover,
retaining
ring and
washers
to allow wheel
removal
(rear
wheels have a square key - Do not lose).
3.
Repair tire and reassemble.
NOTE: On rear wheels only: align grooves in
rearwheel
hub and axle, Insert square
key.
4.
Replace washers
and snap retaining
ring
securely
in axle groove.
5.
Replace
axle cover.
NOTE:
To seal tire punctures
and prevent
flat tires due to slow leaks,
purchase
and
use tire sealant from Sears, Tire sealant also
prevents
tire dry rot and corrosion.
Washers
TO START
ENGINE
WITH A WEAK
BAT-
TERY
,_WARNING:
Lead-acid
batteries
gener_
ate explosive
gases.
Keep sparks,
flame
and smoking
materials
away from batteries.
Always
wear eye protection
when
around
batteries
If your battery is too weak to startthe engine, it
should be recharged.
(See "BATTERY"
in the
MAINTENANCE
section
of this manual).
If "jumper cables"
are used for emergency
starting,
follow this procedure:
IMPORTANT:
Your tractor is equipped
with
a 12 volt system. The other vehicle must also
be a t 2 volt system° Do not use your tractor
battery to start other vehicles°
TO ATTACH JUMPER
CABLES
1. Connect
one end ofthe RED cable to the
PC S ITIVE (+) terminal of each battery'(A-
B), taking care not to short against tractor
chassis.
2, Connect
one end of the BLACK
cable
to the NEGATIVE
(-) terminal
(C) of fully
charged
battery.
3.
Connect
the other
end of the
BLACK
cable (D) to good chassis ground,
away
from fuel tank and battery,
TO
REMOVE
CABLES,
REVERSE
ORDER
1, BLACK cable first from chassis
and then
from the fully charged
battery.
2,
RED cable last from both batteries.
Weak or Dead
Fully Charged
Battery
Battery
Retaining
Ring "-kX
Axle Cover
!
_Square
Key (Rear
Wheel Only)
29
Publicidad
Tabla de contenido
