Event Log - Shure AXIENT AXT600 Manual Del Usuario

Using All New Wizard Option for System Setup
The following example shows the steps for initial RF coordination using the All New wizard option. Use the Update Freqs or Update Devices wi ard options to coordinate an
existing wireless system.
1. From the home menu screen choose
Choose
All New
Setup
Update Freqs
Task
Update Devices
2. The Found Channels screen displays the
Found: 1 Channels Next
AXT J5
Refresh
3. Press the control wheel to place a check-
Select devices to control Next
 [Device1]-
Clear
AXT400
 [Device2]-
Add All
AXT400
 [Device3]-
AXT400 Flash
Power off or RF Mute all Next
4. Mute all transmitters. Press Next.
transmitters the will
receive frequencies
from this coordination
Exclusions
Most RF environments contain frequencies where it is not desirable to operate wireless equipment, such as those reserved for local broadcasts, public safety, or other users.
Exclusions can be entered into the Spectrum Manager to prevent it from including these frequencies in its calculation of a compatible frequency list.
Entering Exclusions
1. Menu: CFL > New > Exclusions
Format
Exclusions
Add
Clear
Clear All
2. Press the menu button next to the Add option.
3. Press the control wheel to highlight TV, Start, or Stop:
• To exclude a single frequency, set the values for the Start frequency and
the Stop frequency to the same value
• To exclude a range of frequencies, use the Start and Stop values to
define the frequency range
• To exclude a TV channel, use the control wheel to set the channel number
4. When finished, press ENTER to save changes.

Event Log

The event log records the actions of the Spectrum Manager and other devices it manages, as listed below. The log stores up to 150 events. The start of an event record is
indicated with an asterisk (*). The most recent events appear at the top of the log. Use the control wheel to scroll through the list of events. When the storage limit is reached,
the oldest events are overwritten.
Note: A power cycle or firmware update will clear the event log.
Frequencies:
• Backup frequency degraded
• Backup frequency upgraded
• Frequency served to [channel
name]
• Scan Stored
Wizard and select the All New option.
frequency band and model of devices on
the network. Press Next.
mark in the box next to the Device ID. Use
the control wheel to select other devices
or press Add All. Press Flash to identify
a specific device in the list. Press Next
when finished.
Managed Devices:
• [Device ID] goes off-line
• [Device ID] comes on-line
• [Device ID] removed
• [Device ID] added
• Transmitter [Tx] profile changed
Scanning
Antenna A
Cursor
dBm
-20
-40
-60
-80
-100
470.000 Mhz 952.000 Mhz
27 compatible frequencies
Deploy
27
Found
frequencies
Writing to Hardware
Exclusions (TV=6 MHz)
TV 32
(578.000-584.00 MHz)
599.000-604.000
MHz
650.000
MHz
In this example, TV channel 32, the
range of 599.00 to 604.000 MHz, and
650.000 MHz will be excluded from
the compatible frequency calculation.
Compatible Frequency List (CFL):
• CFL cleared
• New frequency added
• Frequency deleted
• Frequency value changed
• Frequency type changed
• CFL deployed
• New CFL calculated
8
5. Allow the scan to complete.
Exit
The RF plot is displayed
in the data window. Press
Zoom
Next.
Peak
Exit
6. Allow the CFL calculation to
complete.
Pause
Edit
Exit
7. Press Deploy to assign frequen-
cies to the network devices.
Format
▲
Add
Clear
▼
Clear All
Exclusions:
• Exclusion threshold changed
• Exclusion added (frequency or
range)
• Exclusion cleared (frequency or
range)