System Setup - Philips PH0900 Manual De Utilización

EN
6
Getting Started
The package should contain the items listed below. If any of
these items are not included, notify the shipper or dealer from
which you purchased the product.
Base Unit
The base unit has two phone connectors on the right side
(one labeled PHONE, the other labeled LINE), an indicator light
on the bottom, right corner and a push button on the bottom,
right side. It is also labeled BASE on both the voice/data and
data-only versions.
Extension Unit
The extension unit has a single phone connector on the right
side, an indicator light on the bottom, right corner and a push
button on the bottom, right side. It is also labeled EXTENSION
on both the voice/data and data-only versions.
Six-Foot Telephone Cord
A six-foot telephone cord is provided to connect the base unit
to the existing wall phone jack.

System Setup

System Setup
Follow the steps below to ensure proper functionality of your
Philips Wireless Phone Jack.
Installation
1. Plug the base unit (two phone connectors) into an electrical
outlet near an established wall phone jack.
NOTE: Do not plug base or extension unit into surge
protectors, plug strips, extension cords, other A/C
power extension devices or GFCI protected
outlets.The equipment works best when plugged
directly into electrical outlets.
NOTE: The indicator light on the base unit will illuminate
red, once it has been plugged into the electrical
outlet.