Migatronics FOCUS MIG2 300 Guía Rápida página 4

CLASSIC II CONTROL PANEL
I. Switch on the machine
II. Set wire feed speed
III. Set arc voltage
A B
1
3
4
5
6
2
1 Arc voltage - fine steps
Push of the key increases the arc
voltage in fine steps.
2 Arc voltage - rough steps
Push of the key increases the arc
voltage in rough steps.
3 Arc voltage - infinitely variable
The arc voltage can be adjusted as
required. Press the key under the
symbol and turn the control knob until
the desired arc voltage is achieved.
FOCUS MIG 300: 13-32 V
2
FOCUS MIG 400: 13-37 V
2
4 Wire feed speed
Press the key and turn the control knob
until the desired wire feed speed is
achieved.
5 Control knob
Adjustment of wire feed speed or
arc voltage and inching speed during
wire inching. If the key for secondary
parameters is active, it is possible to
trim the secondary parameters.
6 Selecting trigger mode
Change between 2-stroke (indicator
off) and 4-stroke (indicator on).
2-stroke: The welding process starts
when the torch trigger is activated and
ends when the torch trigger is released.
7
4-stroke: The welding process starts
when the torch trigger is activated
and released, and ends when the torch
trigger is activated again.
7 Secondary parameters
Press the key until the desired
parameter is shown on the display.
Press key 4 briefly to finish.
A Welding voltage
B Warning – overheating
QUICKGUIDE FOCUS MIG
Set welding current (A)
Soft start
Gas post
(m/min.)
flow (t)
Gas pre flow (t)
Burnback
Arc adjust (electronic choke)
1
Remote control
Cooling Press and hold down 4-stroke
key (6) to activate/deactivate cooling using
control knob 5 (FOCUS MIG 2 400 only)
2
UK