Mounting Template Guides - Freud FT1700VCE Instrucciones De Operación

Option 2– Through The Base Bit Changes
The Freud FT1700 can also be mounted to a
router table. To mount the router, please follow the
instructions included with the router table.
a) Unlock the base by inserting the height
adjustment wrench (K) into the above table base
clamp access hole (L) and rotate counter
clockwise until the wrench stops turning.
- Fig. 4a
b) Insert the depth adjustment wrench into the
above table height adjustment access hole (J).
Turn the wrench counter clockwise to raise the
bit and clockwise to lower the bit. - Fig. 4b
c) Once the bit is set at the desired depth of cut,
lock the base by inserting the height adjustment
wrench into the above table base clamp access
hole (L) and turn the wrench clockwise until the
wrench stops turning. - Fig. 4c

MOUNTING TEMPLATE GUIDES

WARNING! Disconnect tool from power source.
For template routing, the Freud FT1700 accepts
standard template guides which are available
separately. To use template guides an optional adapter
ring (Freud FT1100) must be attached to the base
plate using the two slotted screws provided. Remove
the slotted screws from the base plate, insert the
adapter ring with the flat side toward the router body.
Install and tighten the screws to secure the adapter
ring. - Fig. 5
The base plate (L) has been centered at the factory,
however, if the base plate has been removed and
remounted some adjustment may be necessary to
center the template guides to the router bit. To adjust,
loosen the four base plate screws that secure the base
plate to the router, reposition the base plate and
tighten the screws.
English
Base Plate
Screw
Base
Plate Screw
13
Fig. 4a
Fig. 4b
Fig. 4c
Fig. 5
Base Plate
Screw
Adaptor Ring
Screws
Base
Plate Screw