Reviewing Preprogrammed Pads
1. Open oven door.
• Display shows "b" or "d" and "READY".
• Fan and light operate.
• If door is closed or RESET pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold TIME ENTRY pad for approximately
5 seconds.
• After 5 seconds, signal sounds. Display shows
"Pb" or "Pd" indicating "b" or "d" menu.
3. Press MENU b/d pad to select preprogrammed
menu if necessary.
4. Press desired number pad.
• Display shows heating time, "COOK LEVEL" and
power level if other than 100 percent power.
5. Press TIME ENTRY pad to review heating stages
for pad.
• "P(b or d)" and stage show briefly, then heating
time, "COOK LEVEL" and power level if other than
100 percent power show in display.
6. Press START pad after reviewing preprogrammed
pad.
• Display shows "Pb" or "Pd" indicating "b" or "d"
menu.
• Repeat steps 3-6 to review another
preprogrammed pad.
7. Press RESET pad or close oven door to exit
programming mode.
Manual Time Entry
1. Open oven door, place food in oven, and close
oven door.
• Display shows "b" or "d" and "READY".
• Fan and light operate.
• If pad is not pressed in 30 seconds, open and
close oven door again.
2. Press TIME ENTRY pad.
• Display shows "0000" and "READY".
3. Press number pads to enter desired cooking time.
• For example, to heat for 2 minutes 30 seconds,
press 2 , 3, and 0 pads.
4. Press POWER LEVEL pad to change power level.
• Display indicates 100 percent power.
5. Press number pad to enter desired power level.
• For example, pressing 2 pad is 20 percent power.
6. Press START pad.
• Oven operates and time counts down.
• Display shows heating time, "POWER", "COOK
LEVEL".
• Display shows "POWER" only when microwave
energy is present.
• If power level other than 100 percent power was
programmed, display shows "COOK LEVEL" and
power level. Display counts down cooking time.
7. Oven stops heating and oven signal sounds when
heating timing elapses.
10