Premium PBS762 Manual De Uso Y Cuidado página 17

Carefully turn the hob upside down and place it on a
o
cushioned mat.
Apply the sealing strip (A) provided around the edge of the
o
appliance.
The protective covering must be removed from both sides.
o
Do not leave a gap in the sealing agent or overlap the
o
thickness.
IMPORTANT: Do not use a silicon sealant to seal the
o
appliance against the aperture. This will make it difficult to
remove the hob from the aperture in future if it needs to
be serviced.
each corner of the hob. Slightly tighten a screw (C) through
the clamp (B) so that the clamp is attached to the hob, but
so that you can still adjust the position of it.
Carefully turn the hob back over and then gently lower it
o
into the aperture hole that you have cut out.
On the underneath of the hob, adjust the clamps into a
o
position that is suitable for your worktop. Then fully
tighten the screws (C) to secure the hob into position.
Sealing strip
(A)
Clamp
(B)
Screw
(C)
Place the clamp (B)
o
over the holes that
match the size of the
screws. There are one
set of screw holes in
17