Premium PBS762 Manual De Uso Y Cuidado página 20

Remove the control knobs, pan supports, burners, hob
o
fixing screws and clamps.
Remove the hob from the worktop and remove any
o
underside protective covers.
Disconnect the fixings holding the tap to the fascia panel
o
and separate the assembly. Then clean the cone and
seating, with a cloth dampened with solvent.
Lightly smear the cone with high temperature grease,
o
reassemble into position and rotate a few times.
Remove the cone again and remove any excess grease,
o
making sure that the gas ducts are not obstructed with
grease.
Carefully reassemble the components and perform a gas
o
soundness test.
If it becomes necessary to replace a gas tap, then you
o
should proceed as follows:
Remove the control knobs, pan supports, burners, hob
o
fixing screws and clamps.
Remove the hob from the worktop and remove any
o
underside protective covers.
Disconnect the fixings holding the tap to the fascia panel
o
and separate the assembly.
Disconnect the gas pipe from the gas tap, and then
o
disassemble them from the gas rail by removing the fixing
screws.
When fitting a new tap, ensure that a new gasket is used.
o
Reconnect the gas tap, perform a gas soundness test and
o
then reassemble the hob.
20