Publicidad
Please Note: The canopy from the lighting xture MUST cover the can opening. Please make sure that the canopy
is big enough before proceeding.
Installation Instructions:
1. Make sure the power is o . Remove the lamp (If applicable) from the socket.
2. Thread the socket pigtail (M) into the recessed can socket (Figure 1).
3. Take of the mounting bracket (F) and the washer (I) from the inner/outer sections for channel brace (C/D) by
removing the two 1/4" long side screws (H) (Figure 2).
4. Raise the adjustable channel brace (C/D) into the recessed can and slide the inner and outer sections of the
channel brace as wide as possible, so that the both ends of the brace are against the sides of the recessed can,
move the locking bar (E) to the center of the channel brace, then tighten the center screw (G) (Figure 3).
5. Secure the sliding bar to the recessed can, by using the two supplied 1" long self piercing screws (N). By using a
power drill and a 1/4" hexagon driver, drive the two screws through both sides of the channel brace to the side
of the recessed can (Figure 4). Note: Do not use any other type of screw. These screws are speci cally designed for
this application. Only two screws are needed, two extra screws were provided for your convenience.
6. Install the mounting bracket (F) and the washer (I) back onto the channel brace (C/D), by using the two side
screws (H) removed from step 3 (Figure 5).
Note: The washer must be used for 5" & 6" can installations; Do not use the washer for 4" can installation.
7. Install the green ground wire with screw (K) to the side of the recessed can using ground screw (J) (Figure 6).
8. Install your lighting xture's GEM strap (Q) (Not included, it comes with the lighting xture purchased separately)
on mounting bracket (F) with two 1/2" long xture screws (O) (included) (Figure 7). Follow the installation
instructions included with your luminaire to mount onto the recess can converter kit.
9. Make the electrical connection between the pigtail (M) and your xture's electrical wires, and raise the xture
canopy. Secure the canopy according to your lighting xture installation instruction (Figure 8).
Note: Canpoy MUST cover the can opening.
M
F
C&D
H
See Pages 3 & 4 for Spanish and French Instructions
Ver las páginas 3 y 4 para las instrucciones en español y francés
Voir pages 3 et 4 pour les instructions espagnoles et françaises
HINKLEY LIGHTING
Recessed Light Converter Instruction - 80100QF - QuickFit
F
C&D
H
J
K
33000 Pin Oak Parkway
Avon Lake, OH 44012
I
E
G
Patent Pending Rights Associated to Westinghouse Lighting Corporation
(p)800.442.5539 / (f ) 440.653.5555
N
O
www.hinkleylighting.com
Publicidad
