Power Supply; Setting The Clock - THOMSON CR221I Modo De Empleo

Start-up of the device/introduction.
• Remove the protective film from the display if it is still present.
• Press the "STANDBY" button to turn on the device.
• Press the "STANDBY" button again to switch into the standby mode.

Power Supply

You can power your appliance by plugging the AC power cord at the back of the appliance into a wall
AC power outlet. Check that the rated voltage of your appliance matches your local voltage.
Back-up Battery (not supplied)
Open the battery compartment on the backside of the product. Insert 2 x 'AAA' size battery (Battery
not included).
Close the battery compartment.
Note: The back-up battery preserves the clock time in case of a temporary power blackout.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

Setting the clock

The system must be in standby mode in order to set the clock.
1. Press and hold the "CLK. / MEM." button for approx.2 seconds.
2. Use the "SKIP +" & "SKIP -" buttons to set the time format "12 / 24hr".
3. Press the "CLK. / MEM." button to confirm time format.
4. Use the "SKIP +" & "SKIP -" buttons to set the hours accordingly. The hour digits start flashing.
5. Press the "CLK. / MEM." button to confirm the hour.
6. Repeat step 4 and 5 to set the minute.
NOTE:
• Because clock setting is at standby mode, the display is dim.
• You may press and hold the "SNOOZE/DIMMER" button to adjust display lightness.
Setting of the alarm time
The system must be in standby mode in order to set the alarm.
1. Press and hold the "VOL - / ALARM 1" button for 2 seconds to entry alarm set mode.
2. Use the "SKIP +" & "SKIP -" buttons to set the hour accordingly. The hour digits start flashing.
3. Press the "VOL - / ALARM 1" button to confirm the hour.
4. Repeat step 2 and 3 to set the minute.
5. Press the "SKIP +" or "SKIP -" button to select below 1, or 2 for wake-up function.
1 - BUZZ, 2 - TUNE (RADIO)
6. Press the "VOL - / ALARM 1" button to confirm.
7. Use the "SKIP +" & "SKIP -" buttons to set the Alarm volume.
8. Press the "VOL - / ALARM 1" button to confirm.
To set the second alarm time, repeat each of the above steps with the "VOL. + / ALARM 2" button.
In order to deactivate the alarm function, press the "VOL. - / ALARM 1" or "VOL. + / ALARM 2" button.
Snooze
Press "SNOOZE / DIMMER" button to suspend alarm sound for a few minutes.
The alarm will start again after approx. 9 minutes.
Dimmer
NOTE:
This function can be used in both "Standby Mode" and "Turned On Mode"
1. Press and hold the "SNOOZE / DIMMER" button for 2 seconds to select dimmer. Dimmer has 3 steps.
- EN 5 -