Basic Application - Maxxsonics MB QUART PREMIUM PAB 2100 Instalación Y Funcionamiento

AMPLIFIER APPLICATIONS
PAB 1200.1 D Mono Amplifi er

Basic application

Interconnect cable checklist:
- Connect the line inputs to a Radio/CD RCA outputs or line output
of the full range primary amplifier with good quality RCA cables. A
"Y" adapter may be needed as shown in the diagram.
- Use at least 16 gauge speaker wiring. These amplifiers have dual
speaker terminals, simplifying the hookup of multiple speakers
Crossover frequency control checklist:
- LOW PASS: 35Hz to 250Hz
- SUBSONIC: 10 Hz to 50 Hz
- BASS EQ: 0 to 9 dB
- PHASE: 0 to 180 degrees
MBQR-1
*Note: You can use the Radio/CD designated mono line output or a full range stereo line output.
For full range stereo line output, you will need an optional "Y-Adaptor" as shown
Level control checklist:
Refer to the section "Setting up systems after installation for best
performance"
Minimum final loudspeaker impedance: 1 ohm
13