Ebac 2000 Serie Manual De Instrucciones página 60

Fan speed control
Adjusting the fan speed
You may wish to change the fan speed of your Ebac from time to time. Using the Normal setting will remove more
moisture from the air compared to the Quiet setting thereby improving efficiency. When switched on, your
dehumidifier will default to level 1.
Pressing the fan speed button will scroll through the settings below, after standby mode it will return to setting 1.
Setting Function
1 Low setting for quiet operation
2 Normal setting
3 Continuous Fan Mode Quiet
4 Continuous Fan Mode Normal
5 Standby position
The speed of the fan is indicated by the green fan symbol – the higher the setting the faster this symbol rotates.
Air Cleaning: When fitted with one of our high performance filters, your dehumidifier may also be used as an air
cleaner. To do this, press the Fan speed & Air cleaning button until the fan symbol turns yellow. Pressing the Fan speed
& Air cleaning button again will increase the Fan speed for faster air filtration.
Standby: When selected, the dehumidifier will not operate. This allows the dehumidifier to be switched off without
adjusting the humidistat setting. Standby mode is indicated by the power-on light turning yellow.
Boost Control: The boost control on your Dehumidifier allows the setting of the humidistat or Smart Control and fan
speed to be overridden for a set period of time to maximise water extraction from the air. This is ideal for laundry
drying etc.
To select this function press the mode button until MAX flashes on the control panel. The unit will now run on
maximum fan speed and at full-power for a period of 8 hours. After this time the unit will return to the settings you
had prior to activation.
Note: As the mode button changes a number of functions, the settings remembered are those made 10 seconds prior
to boost being activated.
60
GB