Installation Instructions - EVERSPRING HSP01 Guía De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

HSP01
PIR Motion Detector

Installation Instructions

General Introduction
The HSP01 PIR Motion Detector is a U-Net device and is fully compatible with other
U-Net devices. This Detector is designed with a Passive Infra-Red (PIR) sensor and
light sensor in order to fulfill the purpose of security and home automation. It detects
motion by monitoring changes in infra-red radiation levels emitted by body heat. Its
great compatibility with our U-Net family security products makes it suitable for
smart home cloud based platforms such as HomeSys.
Product Overview
PIR Lens
LED
(hidden
behind
PIR lens)
LED Indication
Red LED
Used to indicate trigger events, low battery power, and warm up
Green LED
Used to indicate key learning controls
Orange LED
Used to indicate no codes learned
Binding with HomeSys
1. Undo and remove the fixing screw from the bottom of the detector. Carefully
pull the bottom of the detector away from the rear cover and then slide down to
release the top clips.
Tamper Switch
Battery
/ Link Key
Fixing Screw
2. Prepare a CR123A battery. Do not insert the battery into the unit yet.
3. Log into the HomeSys account from a web browser.
4. Select "System" then "Add a Device".
5. Select "PIR Detector".
6. The following screen will appear. This means the gateway is entering
binding mode.
1

Publicidad

Tabla de contenido
loading

Productos relacionados para EVERSPRING HSP01

Tabla de contenido