Reset To Factory Settings - EVERSPRING HSP01 Guía De Usuario

7. Perform the test using the same steps described in Operation & Testing section
above to ensure the unit is working properly. By walking into the protected area
with coverage of 110 degrees, the detector will now be triggered each time it
senses movement. Note that the detector can only be triggered once every 30
seconds when mounted on the wall.
Maintenance
Low Battery: When the battery becomes low, the LED will flash red when
motion is detected to indicate low battery condition to the user.
Troubleshooting
The troubleshooting table lists some possible causes and solutions. Please contact
your original retailer or nearest service center if the below solutions cannot solve
your problem.
Symptom Cause of Failure
LED cannot be displayed 1. Run out of battery
power.
2. Check if reverse battery
polarity.
The detector is not working 1. The PIR detector cannot
communicate with the
gateway HSC04.
2. Check if the detector is
out of order.
After the two-minute warm 1. Check if detector has
up is completed, the completed binding with
detector does not work HomeSys Gateway
and LED flashes on and
off repeatedly at with an
interval of 2 seconds

Reset to Factory Settings

1. Press and hold the link key on the PCB for 3 or more seconds, and the
detector LED will start to flash.
2. Press and hold the link key for 6 or more seconds within 30 seconds until the
LED turns off. The device is now reset back to factory mode
Specifications
Battery
Operating Temperature
Warm Up Time
PIR Detection Coverage
Operating Frequency
** Specifications are subject to change without notice.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
Recommendation
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
1. Replace a new battery.
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
2. Refit the battery with
correct polarity.
energy and, if not installed and used in accordance with the instructions, may cause
1. Place the PIR Detector
harmful interference to radio communications. However, there is no guarantee
closer to the gateway.
that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
2. Send the device in for
interference by one of the following measures:
repair and do not open it.
1. Remove the battery and
follow the steps for -
"Manual binding".
-
-
-
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
4
CR123A 3.0V 1700mAh Lithium Battery
-10°C to 40°C
About 2 minutes
Wall-Mounted:
Up to 10m x 110° (at 1.8m mounting height & 25°C)
868MHz (EU)/ 923MHz (America)
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.