Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.8 cu ft DRYER (STYLE 2) INSTRUCTIONS
C
) Attaching dryer (style 2) mounting
3
hardware
1.
Use the following instructions for mounting any of these types of
dryers to the pedestal:
Dryer cabinet (style 2)
with 2 indents on side
and 4 inch knockout for
side venting.
2.
Attach each front clip to outer-most set of holes with 2 screws.
NO spacers under front brackets.
3.
Insert "B" tab of each rear bracket into the front slots on rear of
pedestal. Orient bracket outward for "style 2" dryer mounting.
"B"
tab
front
slot
4.
Install 2 screws through each rear bracket into aligning pedestal
holes.
D
) Mounting dryer (style 2)
3
back or other injury, have more than one person move or lift
the dryer.
1.
Using two or more persons, slightly tip the dryer back and lift it
onto the pedestal. Still tipped, slide the dryer back against the
rear brackets so tabs on rear brackets engage the slots on the
back of the dryer. Gently set down the front so the appliance is
between the front and rear brackets.
SLIDE BACK
2.
Adjust the appliance side-to-side to align its mounting holes with
the pedestal's bracket holes.
3.
With the pedestal drawer open for better access, install a screw
through each front bracket into the base of the dryer.
outward
E) Installing or re-installing dryer (style 2)
1.
Slide appliance/pedestal into place.
2.
Check for levelness and rock all four (4) legs again. Repeat until
level and solid.
3.
Refer to
Dryer Installation Instructions for complete details on
installing electrical, gas, or exhaust venting.
5
- EXCESSIVE WEIGHT HAZARD -
ENGAGE REAR TABS
TIP DOWN
To avoid
Publicidad
Tabla de contenido
