hager WDI07 Serie Manual Del Usaurio página 22

z
Connecting and installing the device
The RJ45 installing connector is mounted on
the network cable.
Connect the jack to an RJ45 socket on the
„
touch panel (7/8) using the enclosed, pre-as-
sembled RJ45 patch cable.
If required connect a 24 V DC power supply
„
(see Accessories) using the enclosed termi-
nal (9). Ensure correct polarity (figure 2/3).
(15) Flush-mounted housing (not included in
scope of delivery)
If a device is mounted flush with the wall,
„
guide it into the housing by applying even,
slight pressure on the left and right (Figure
>>
13) until the Push-to-open
housing engages.
When pushing in the touch display into the
housing, make sure that the connected
cables do not get wedged in.
22
Figure 12 a/b: Installation in the flush-mounted housing
<<
lock of the
Insert touch panel in the housing (21) in
„
such a way that the mounting plates (22) of
the housing are pushed under the frame.
Tighten the four screws and the mounting
„
plates through the frame from above and below
using the enclosed Allen key (Figure 12/13).
The screws must be countersunk in the frame.
(16) Mounting brackets
Remove the protective foil from the user
„
interface.
Switch on auxiliary voltage.
„
The device charges the operating system/
Launcher and displays the desktop interface/
home page of the Launcher after a few sec-
onds. Device is ready for operation.
(22)
(21)
(22)