Safety Instructions - Super Ego SEHO19300 Manual Del Usaurio

Explicación de símbolos
Wear ear protection.
Wear eye protection.
Wear a dust mask.
Wear protective gloves.
Read the operating manual.

Safety instructions

WARNING!
Read all safety notes and instructions. This
operating manual contains important and
useful information about the correct operation of
this product.
Failure to comply with the safety notes and
instructions can cause electric shock, fire, and/or
serious injury.
The manufacturer can accept no responsibility for
damage to persons or property and / or consequential
damages caused by incorrect use of this product or
by failure to follow the operating manual and safety
instructions. Incorrect use of this kind will invalidate
the warranty and the guarantee.
1. Keep children and other people out of the area
when operating this product.
2. Treat this product with care. Ensure the moving
parts function correctly and do not stick. Check
whether parts are broken or so badly damaged
that that the device's functions are impaired.
Have damaged parts repaired before operating
the device.
3. It is not possible to operate the device safely if
the device shows visible signs of damage, does
not function properly, was stored for a longer
period of time under unfavourable conditions
or has been damaged in transit. In any of these
cases stop using the product and secure it so
that it cannot be unintentionally switched on.
4. Put the device into its plastic case after cleaning
or using it and store it in the plastic case, out of
the reach of children when it is not in use.
5. Operation of the device in areas where there
is a risk of explosion or operation on persons
or animals is not permitted and could lead to
injury or danger.
6. Use the device and any accessories or tools etc.
according to these instructions. Plan the type
of work you wish to do carefully. The use of
this device for applications other than those
intended can lead to dangerous situations.
7. Do not expose the device to excessive
mechanical stress or vibrations. Do not bend
the flexible shaft further than the specified
minimal bending radius.
8. Only the camera, the LED light and the flexible
shaft may be immersed on liquid. Do not
immerse the camera or shaft in liquid carrying
electric current. Do not immerse the camera
and flexible shaft in more than 90 cm of liquid.
Observe the marking on the flexible shaft for
this purpose. The handle and the monitor must
be kept dry and may not be exposed to liquids.
9. Turn the device off and allow it to reach room
temperature before exposing it to variations
in temperature. Otherwise condensation can
form, which under certain circumstances can
damage the device.
10. Do not stare into the LED light as it can dazzle
you or damage your eyes.
11. Modifications to the device are not permitted.
Explicación de símbolos
TFT monitor: 2.4" / 6 cm screen diagonal.
Resolution: 320 x 240 pixel.
Max. viewing angle: 54º.
Video format: NTSC.
Camera illumination: 2 white LEDs.
LED: LED Class I according to EN 60825-1:2002.
Power source: 6 V/DC (4 x AA/LR6-Batteries).
Rated power: Máx. 200 mA.
Ambient / operating temperature: 0° C - + 45 ° C.
Flexible shaft length: approx. 90 cm.
Minimum bending radius: 45 mm.
Camera diameter: 10 mm. Ø.
Insulation category - flexible shaft: IP 67.
Weight (without accessories): approx. 360 g.
ENGLISH
This product may only be used for
technical inspections.
Not for use on persons or animals
9